Electrostatic Ignition Hazard
Warning! Verify the area is not hazardous when installing, servicing, cleaning, or
touching the Itron device.
Device Cleaning
Warning! Clean only with a damp cloth.
Do Not Drop
Warning! While Itron meters are designed to withstand a drop, dropping the meter
may damage the device, impact the meter accuracy, and void the warranty.
Product Notification
These instructions are not intended to replace any utility or company-established meter install-
ation procedures. These instructions are provided for additional information when the Intelis Gas
Meter is installed. The meter installation must comply with all country, state, and local building
and safety regulations as well as federal regulations including Section 192.353 of Title 49 of the
Code of Federal Regulations. Two pertinent paragraphs of the code are:
■
Each meter and service regulator, whether inside or outside of a building must be in a readily
accessible location and be protected from corrosion and other damage.
■
Each meter installed within a building must be located in a ventilated place and not less than
3 feet from any source of ignition or any source of heat which might damage the meter.
The Intelis Gas Meter is rated for the following operating and storage temperature ranges. Use
of the meter outside of the listed temperature ranges is not recommended.
■
Operating ranges:
–
Measurement -30° F (-34° C) to +131° F (55° C)
–
Valve -13° F (-25° C) to +131° F (55° C)
–
RF -40° F (-40° C) to +158° F (70° C)
■
Storage range:
–
-40° F (-40° C) to +158° F (70° C)
■
Direct inquiries as to the selection and application of gas meters to your local Itron sales rep-
resentative or Itron Support.
11 December 2019 TDC-1782-005 8
Intelis Gas Meter Installation Guide 1 Important Safety and Compliance Information
To Next Page
Loading...
Need help?
General
