3
Installation
This section provides the Intelis Gas Meter installation information.
Warning! This product, as of the date of its manufacture, is designed and tested to
conform to all governmental or industry safety standards then existing as they may
apply to the manufacturer. The purchaser and user of this product are warned that
compliance with all country, state, and local codes required in order to avoid the haz-
ards of leaking gas resulting from improper installation, start-up, or use of this product,
and further, that all fire control, building codes, or other safety regulations established
under public laws which regulate or govern the application, installation, operation, or
general use of this product, should be complied with. In order to ensure the safe and
proper operation of this product, the manufacturer recommends that a qualified tech-
nician install this product.
The Intelis Gas Meter must be installed with the inlet to the left, the outlet to the right, the meter in
a horizontal position and with the LCD facing out. INLET and a flow arrow are marked on the
Intelis Gas Meter casing.
Note: These instructions assume the gas is turned off, the previous gas meter is removed
(when the Intelis Gas Meter is replacing an existing installation), piping tests are completed,
and all safety requirements are met.
11 December 2019 TDC-1782-005 16
To Next Page
Loading...
Need help?
General
