ITW Dynatec
D SERIES V6 DCL ASU Manuals
Troubleshooting Page 7-31
Revised 10/14
roubleshooting the
SU
ump
No special tools are needed for working on the ASU pump. See Chapter 8 of this manual for dis-
assembly/ assembly procedures f or the ASU pump, and Chapter 10 for locating pump parts on the
component illustrations (exploded-view drawings).
Gear Pump Priming/ Start-Up
The pump is self priming.
CAUTION: DO NOT continue to run the pump if no glue is coming out. This could
damage the pump since it uses the glue as a lubricant. Stop and t roubleshoot.
To Next Page
Loading...
