ITW Dynatec
D SERIES V6 DCL ASU Manuals
LCD Programming Page 5-5
Revised 10/14
To Navigate Away from the Overview Screen
PressThisButton To:
System Configuration Go to the System Configuration Menu to program the temperature
unit, language , setpoint limitation, hi/ low tolerance, setback
temperature, level control, heat‐up sequence, pump enable
temperature, access code, 0.5 RPM increments, temperature offset,
zone names, power‐on configuration or view the logbook.
Menu Go to the Main Menu screen to program recipes, set‐back mode,
keypad locking and the 7‐day scheduler or to go to the Help Screen
Pump Go to the Pump/ Motor screen to program pump parame ters
Return Return to the previous screen
F1, F2, F3, F4 Go to the temperature zones (use as shortcuts)
F5 Go to the Pump/ Motor screen (alternative method)
Overview Screen Example
The Overview Screen illustrated below illustrates an example of a typical system. This melter has
two premelt (drop‐in) grids and two hopper heaters for a tota l of four ASU temperature zones.
The screen also shows six hoses and four pump/ motors. There are additional temperature zones
in this system, not seen on this screen, as indicated by the flashing arrows.
Premelt symbol, showing two
temperature zones
Hose symbol, showing six
temperature zones
Flashing arrows = turn Input Wheel to view more zones
(ie, Applicator and Aux zones),
Four pumps are run‐
ning. Their speeds (in
rpms) are shown
System Status Pump Status
or push to go back and forth to more zones.
To Next Page
Loading...
