134
Remote
control
Transmitter
On
the
transmitter
there
are:
I. Push-button control.
2.
Optical indicator
(LED).
3.
Metal plate with stamped
code
number.
Receiver
On
the
receiver
there
are a push-button 5 for memorizing
the
code
given
out
by
the
tran-
smitter and a led 4 for
signal
display
The
receiver can memorize
up
to
six
different codes. corresponding
to
six
differenttransmit-
ters
(vehicle used
by
up
to
people).
How
to
programme the remote control
a.
Press and hold
the
programming push-button
5;
led 4
lights
up and remains litto indicate
"ready
to
receive code".
b.
Keeping
the
push-button 5 pressed.
operate
the
push-button I
of
the
transmitter.
The
extinction
of
led 4 on
the
receiver means
that
code has been received.
c.
Release push-button
5.
At this point, led 4 flashes for
about
15
sec.
Led
flashing
means
that
the
code has been memorized and
the
universal code has been cancelled.
By
again pressing push-button 5 (while
the
led flashes),
the
operator
starts
again
from
point a
in
order
to
programme any further code
(in
case
of
a vehicle used
by
more than
one
person).
To Next Page
Loading...
