Daily City TurboDaily City
135
How
to
programme new codes
The receiver can memorize up
to
six
different codes.
To
programme a new code, proceed
as
follows:
d.
Press and hold
the
programming push-button
5.
After about 2 sec. led 4
will
blink
out.
e. Keeping
the
push-button 5 pressed,
operate
the
push-button I
on
a transmitterwhose
code
is
already memorized
in
the
receiver.
Led
4
lights
up
fixed.
f.
Operate
the
push-button I
of
a new transmitter. After
about
0,5 sec. led 4 out,
meaning
that
the
code
of
the
new transmitter has been received.
g.
Release push-button
5;
led 4 flashes for about
15
sec. meaning
that
the
new code has
been memorized.
h.
To
immediately
fit
another
code, while led 4
is
flashing,
press and keep pressed
the
push-
button
5.
The cycle starts again from point
c.
Manual
access
programming (transmitter
loss)
It
is
possible
to
programme a
new
code
without having a transmitterwhose
code
has already
been memorized
in
the
receiver (for example
in
case
of
transmitter loss).
In
this case, it
is
necessary
to
have
the
metal plate
3,
supplied along with
the
original
transmitter
that
has lost.
On
this metal plate are stamped four numbers, representing
the
code
to
input following
these
instructions:
i.
Press twice
the
programming push-button
5.
Led
4 gives
three
flashes and extinguishes
after about
2,5
sec.
I.
When
led 4
lights
again,
press
the
push-button 5 as many times
as
indicated
by
the
first
figure
on
the
metal plate (O=do
not
press). After
about
2,5
sec. from
the
last pressing,
led 4 dies
out
for a further 2,5 sec.
m.
Repeat
the
operation from point
I.
to
input
the
other
code figures on
the
plate.
If
this
manual operation
is
carried
out
correctly, led 4
will
start
flashing.
At
this point,
to
input
a new code
it
is
necessary
to
have a new transmitter and go back
to
point
h.
To Next Page
Loading...
