Iveco daily - Rearview Mirrors; Electrical Rearview Mirror Control; Power Window Control Switch

Use of controls
Rearview mirrors
Position rearview mirrors manually by forcing on the sides of reflecting surfaces.
Electrical rearview mirror control (where fitted)
It is located on the driver's side
I. Control knob to adjust the mirror horizontally or vertically in the arrow directions.
2. Switch for selecting adjustment of either right or left mirror.
Power window control switch (where fitted)
3. Left window regulator.
4. Right window regulator.
In the event of a failure in the power window mechanism, you can wind the window up or
down manually using the following procedure: Remove the protection cap and insert the
special device provided with the kit into the proper hole (see illustration).
Screw
in knob 5 completely and then either raise or lower the window by means of
knob 6.
23
~I). ~
-
-
<1[0)1>
~v~
iJ
~
foE)
OO.JI
~ T
1 'I
,
~