Starting and
driving
Engine
starting
Ifit
is
required
to
startthe vehicle
in
a
garage
or
workshop, ensure thatadequate
ventilation
is
provided.
• Turn battery isolation switch (where fitted). inside the engine hood.
• Insert the
key
in
the ignition switch
and
turn clockwise
to
position I (MAR).
.8 Models only
Wait 5
to
7
secs.
for
preheating
plugs
to
be turned on
and
dashboard warning light
to
go
out.
•
Turn
the
key
to
position 2
(AW)
and
release
it
as
soon
as
the engine starts.
without
depressing the accelerator pedal.
(Ifthe above instructions are
not
carefully followed, a puff
of
black smoke will be emitted
on
starting the vehicle).
• Ifstarting does
not
occur immediately, do
not
operate the starter
motor
for
longerthan
30
seconds.
After
starting the engine. proceed slowly and keep engine at
an
average speed until
normal operating temperature
is
reached.
By
this method it
is
possible
to
obtain:
• Optimum oil flow throughout the lubrication circuit.
•
Exhaust
gases
within the specified limit.
•
Fuel
economy.
A Important!The engine should
be
allowed
to
idle (either
warm
or
cold)
for
quite
~
a long time
so
as
to
obtain optimum performance
and
a reduced quantity
of
noxious emissions.
Ignition switch positions
O.
=
Key
in
and
out
- engine stopping - steering lock.
I.
Engine
pre-starting and various auxiliary functions.
2.
Engine
starting
35
To Next Page
Loading...
