Device Messages and Troubleshooting
118
Device does not shut down Milling jobs currently being
processed haven’t been
finished
• Wait until processing has
finished.
• Try to repeat shut-down.
No network connection • Check network
connection and restore if
necessary.
• If the problem continues:
Please contact the in-
house technician.
Fault in the machine • Contact your authorized
service partner.
Water loss Tank defect • Place the machine out of
order and unplug from
the power supply.
• Contact your authorized
service partner.
No milling jobs are shown in
the job list.
No milling jobs transmitted
by the CAM software
(depending on the system
architecture)
• Transfer milling jobs to
the milling machine
(again).
No network connection • Check network
connection and restore if
necessary.
• Transfer milling jobs to
the milling machine
(again).
• If the problem continues:
Please contact the in-
house technician.
Milling jobs will not start. Tasks haven’t been finished:
None or incorrect tools /
blocks have been inserted
for the milling job.
• Insert a suitable tool /
block (“Inserting tools”,
page 89 and “Inserting
blocks”, page 99).
The tank is empty, filter is
full, no PrograMill Fluid for
One coolant concentrate
was used
• Check tank and filter
(“Changing/Refilling the
water in the main tank
and changing the filter”,
page 83).
Error Possible reason(s) Solution
To Next Page
Loading...