Ivoclar digital PrograMill One - Page 119

Device Messages and Troubleshooting
119
Failed milling job Tool / block is broken • Eject tool / block
(“Removing unnecessary,
worn or defective tools”,
page 95).
• Insert a suitable tool /
block (“Inserting tools”,
page 89 and “Inserting
blocks”, page 99).
Construction error in the
CAD software
• Check the construction
and settings in the CAD
and CAM software.
• Transfer milling jobs to
the milling machine
again.
Error in the work
preparation or milling path
calculation in the CAM
software (depending on
system architecture)
Tool / block not recognized Non-approved tool / block
without suitable Data
Matrix Code has been
inserted
• Eject tool / block
(“Removing unnecessary,
worn or defective tools”,
page 95).
• Insert a suitable tool /
block (“Inserting tools”,
page 89 and “Inserting
blocks”, page 99).
• Register tool / block
manually (“Manually
registering a non-
identified tool”, page 123
and “Manually registering
a non-identified block”,
page 121)
Data Matrix Code is
scratched or damaged
Tool / block is recognized,
but not assigned to the
desired milling job
Wrong tool / wrong block
for the milling job inserted
• Eject tool / block
(“Removing unnecessary,
worn or defective tools”,
page 95).
• Insert a suitable tool /
block (“Inserting tools”,
page 89 and “Inserting
blocks”, page 99).
• If the problem continues:
Contact your authorized
service partner.
Error Possible reason(s) Solution