Device Messages and Troubleshooting
120
Tool / block is broken Tool service life has been
exceeded.
• Eject tool / block
(“Removing unnecessary,
worn or defective tools”,
page 95).
• If tool / block cannot be
removed: Contact your
authorized service
partner.
• Check the construction in
the CAD and CAM
software.
• Transfer milling jobs to
the milling machine
(again).
• Insert a suitable tool /
block (“Inserting tools”,
page 89 and “Inserting
blocks”, page 99).
Construction error in the
CAD software
Error in the work
preparation or milling path
calculation in the CAM
software (depending on
system architecture)
Error Possible reason(s) Solution
To Next Page
Loading...