IWILL FB24624100 - Jumper JPSKMV1: PS;2 Standby Voltage

3: Motherboard Configuration
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
User’s Manual
3•5
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Jumper JPSKMV1: PS/2 Standby Voltage
This jumper controls the voltage to the PS/2 keyboard
and mouse ports. The default setting is for standard 5V
operation. The alternate setting configures the PS/2 ports
to also operate with a standby voltage of 5V. This allows
the system to wake up from an S3 Suspend state. If you
anitcipate using this Suspend mode, you should set this
jumper to the alternate setting.
JPSKMV1: PS/2 Standby Voltage
Setting Function
Short 1-2 PS/2 Voltage 5-Volt [Default]
Short 2-3 PS/2 Standby Voltage 5-Volt
JPSKMV1
JPSKMV1 PS/2 Voltage:
Default – 5V
Pin 1