50
UMG 511
Communication
The UMG511 has an Ethernet and a RS485 inter-
face.
Ethernet (TCP/IP)
Select the type of address allocation for the Ether-
net interface here.
DHCP mode
• OFF - IP address, Netmask and Gateway are
specifi ed by the user and set directly on the
UMG511. Select this mode for simple net-
works without a DHCP server.
• BOOTP - BootP permits the fully automatic in-
tegration of a UMG511 in an existing network.
BootP is an older protocol and does not have
DHCP‘s extent of functions.
• DHCP - Upon starting, the UMG511 automati-
cally collects the IP address, the Netmask and
the Gateway from a DHCP server.
Factory pre-setting: DHCP
The UMG511 may only be connec-
ted to the Ethernet after coordina-
ting with the network administrator!
m
To Next Page
Loading...
Need help?
General
