Janome Skyline S7 - ORDINARY SEWING MODE; Ordinary Stitch Patterns

23
Mechanical adjustment
Needle threader hook position
1. Push down the threader lever and hold it just before
the threader hook enters the needle eye.
2. If the threader hook is not aligned vertically with the
needle eye, loosen the setscrew A. Adjust the stopper
position so that the hook enters into the needle eye.
Tighten the setscrew A.
3. If the threader hook is not aligned leterally with the
needle eye, loosen the setscrew B. Adjust the lateral
position so that the hook enters into the needle eye.
Tighten the setscrew B.
Setscrew B
Setscrew A
Stopper