JCM Technologies KEEROLL - KEEroll Verification Procedures; Verifying Control Panel Operation; Radio Communication Quality Check

Verification
Verify that the control panel is working properly
Once the control panel is correctly wired and programmed, check that all the system (accessories included) is working prop-
erly.
Transmitter
Press the transmitter button and check that the door opens. Press again, and check that the door stops/closes.
Photocell
Check that the LED is at OFF.
If the photocell is activated when the door's moving, the LED will pass at ON, indicating the activation of the photocell.
RadioSens3, RadioBand3 system or safety edge
Check that the LED is at OFF.
If the safety element is activated when the door's moving, the LED will pass at ON, indicating the activation of the safety
edge.
Communication’s quality
To ensure that the radio communication is good enough, check that the LED is at OFF. If is permanently activated,
please check RadioSens3/RadioBand3.
jcmtechnologies
18