Impact detection adjustment
To adjust the impact detection of the RadioSens3 system, change the sensibility selector between 0 and 4.
Position Sensibility Application example
0---4 Maximum Slow doors (0,1 m/s)
5---7 Medium Average speed doors (0,5 m/s)
8---9 Minimum Fast doors (>1 m/s)
If the position of the sensibility selector is changed, it is necessary to reprogram the RadioSens3
transmitter on control panel as safety elements programming (not the manoeuvre).
Programming
Enter Installer mode: Hold (KEEroll programming button), the maintenance indicator lights on, a beep will
be heard.
Press the PROG button of RadioSens3 transmitter, a beep will be heard once it is programmed.
Press again to exit Installer mode, lights off and two beeps will be heard.
RadioSens3 and RadioBand3 cannot be programmed together. Only one of
them can be operational.
Maintenance
Batteries replacement
If the led is at ON, the RadioSens3 connected has no battery.
Proceed to replace the two batteries for new ones, taking care of the polarity marked on the connector. Check that the new bat-
teries support the same range of temperature that the ones replaced. Do not mix new and old batteries. Battery duration: 2
years approximately.
Battery type: 2 x 1,5VDC LR6 AA
jcmtechnologies
23
To Next Page
Loading...