JCM Technologies KEEROLL - SESAME Maintenance and LEDs; Resetting the SESAME Device; SESAME LED Status Indicators

48 pages

To Next Page

To Previous Page

Verification

Maintenance

Resetting the device

Reset the device if changing the Wi-Fi network or your Wi-Fi password. To reset SESAME, press the WPS/ RESET button for

10 seconds, with the device connected. The LED “Status” will be set to green, and “Network" and "Internet" to flashing red.

Stop pressing the button when "Internet" goes off and "Network" is fixed to red.

jcmtechnologies