JCM Technologies KEEROLL - KEEpad & KEEpush Programming; Programming the KEEpad Transmitter; Programming the KEEpush Transmitter

Programming
Press the key (you hear a beep and the key lights on) until you reach the necessary channel settings (see "Transmitter
programming" table for the different settings).
You can only access settings with the door closed and the DIP 1 selector OFF.
KEEpad
Wake up Enter the channel password to be programmed + OK
The defaults passwords are: 1111 for channel 1, 2222 for channel 2 and 3333 for channel 3.
KEEpush
Wake up Press any button
Press again to exit transmitter programming. The key light will switch off.
jcmtechnologies
32