KEEalarm
Programming
The KEEroll dipswitch 4 in ON position.
Press the key (you hear a beep and the key lights on) until you reach the necessary channel settings (see "Transmitter
programming" table for the different settings).
You can only access settings with the door closed and the DIP 1 selector OFF.
In channel 4 configuration (4 flashes), slide the KEEalarm device in front of the magnetic part to activate the alarm. A beep
will be heard to indicate that the device is programmed.
Press again to exit transmitter programming. The key light will switch off.
jcmtechnologies
38
To Next Page
Loading...