Safety – 5
Compliance
FCC Compliance
The Federal Communications Commission (FCC) of the United States of America requires that
equipment operating in that country does not cause interference to communications. The unit
has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of Title 47 of the Code of Federal Regulations for Radio Frequency Devices. Operation
is subject to the following two conditions, which the FCC requires to be labeled on the unit:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
FCC rules require that the following note and subsequent information be included in this
manual:
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
These limits are designed to provide reasonable protection against harmful interference in a
commercial installation. The unit generates, uses, and radiates radio frequency energy and, if
not installed and used in accordance with instructions, can cause harmful interference to radio
communications.
Any user modification made to the unit voids the user’s authority to operate the unit under the
FCC rules.
If this unit is used in a residential setting, resulting interference must be corrected by the user.
For more information, see Title 47 of the Code of Federal Regulations at
http://www.access.gpo.gov/nara/cfr/cfr-table-search.html.
CE Compliance
The unit has been designed and tested to comply with directive 73/23/EEC and its subsequent
amendments by the European Community (EC or CE). The directive relates to electrical
equipment designed for use within certain voltage limits. It ensures that electrical equipment is
constructed with good engineering practice in safety matters.
The unit has been designed and tested to comply with directive 89/336/EEC and its
subsequent amendments. The directive relates to electromagnetic compatibility. It demands
that electromagnetic disturbance does not exceed a prescribed level; that the equipment be
immune to a prescribed level of ambient level of interference; that the equipment be protected
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
