Chapter 12 IP Video Testing
VideoCheck test
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 99
If monitoring on an Ethernet interface, you may need an Ethernet hub (such as a NETGEAR®
EN 104) between the CO and the set-top-box, as shown in Figure 20 below.
To run IP video tests in Monitor mode
1 Verify that the network connection is established.
2 From the main Video menu, select a result menu.
– To view results for a specific stream, select Stream 3 Results (or the desired stream
number).
– To view total results for all streams, select Video Results.
3 Use the left or right arrow key to scroll through the screens.
4 To save a test report, press the utility (i) key and then select Save Report, and then specify
the report settings such as report name, report format, technician ID, location, and other
settings as needed.
5 To clear (or reset) the results, use the * key.
This will either Clear Stream if you are on a Stream Results menu or Clear Stats if you are on
the Total Video Results menu.
See “Video results” on page 132 to learn what your results mean.
VideoCheck test
The VideoCheck test is an automated test used to verify the channels are provisioned as the
subscriber requested. See “Running the VideoCheck test” on page 34.
Figure 20 IP video monitoring with a hub
STB
CO
Ethernet Hub
Network
`
To Next Page
Loading...
