JDS Uniphase SmartClass - Specifying WAN Settings

Chapter 6 DSL Testing
Specifying test settings
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 55
To specify Network settings
1 From the ADSL or ADSL/VDSL menu, select Network.
2 Select Network Setup and then specify the ATM Layer Setup. This selection is greyed out if
you specified PTM transport mode on the DSL setup. The following table describes the
settings.
3 Specify other network settings as described in “Specifying the network setup” on page 42.
The network settings are specified.
Specifying WAN settings
If the modem operation mode is Router, the WAN Setup is available. If using Bridge mode, specify
the Network Setup.
To specify WAN settings
1 From the ADSL/VDSL or Bonded menu, select Network, and then select WAN Setup.
2 Select ATM Operation and then specify the settings. This selection is greyed out if you speci-
fied PTM transport mode on the DSL settings menu (Broadcom only).
The following table describes the settings.
CAUTION: FAULTY RESULTS
Any time the Network settings are changed, the network layer resets. If you change these set-
tings during a test, you may cause errors in the test. Only change them before you begin a test.
Setting Description
WAN VPI / VCI Specifies the VPI and VCI for the customer-facing port on the DSLAM.
Encapsulation Select LCC-SNAP or VC-MUX.
CAUTION: FAULTY RESULTS
Any time the Network settings are changed, the network layer resets. If you change these set-
tings during a test, you may cause errors in the test. Only change them before you begin a test.
Setting Description
Data Mode Select the network type. (only in Router mode)
None turns the data layer off
–
IPoE is IP over Ethernet
– PPPoE is PPP over Ethernet
–
IPoA is IP over ATM
–
PPPoA is PPP over ATM
IP Mode Select either Static or Dynamic (DHCP).
IP Addr. If the IP Mode is Static, enter the IP address that the tester will use.
Netmask If the IP Mode is Static, enter the net mask address.
Gateway If the IP Mode is Static, enter the gateway address.
DNS Server If the IP Mode is Static enter the address of the DNS server.