Chapter 6 DSL Testing
Connecting to the line
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 57
4 Specify the Mac Addr. Mode —
factory default or user defined.
The WAN settings are specified.
Specifying LAN settings
If the modem operation mode is Router, the LAN Setup is available
To specify LAN settings
1 From the Network menu, select LAN Setup, and then specify the settings. The following table
describes the settings.
The LAN settings are specified.
Connecting to the line
The method used to connect to the line varies depending on the test mode and line configuration.
Connecting to a single twisted pair
To connect to a single twisted pair
1 Using the RJ-45 to telco clips cable, connect the RJ-45 to bed of nails test lead to the DSL
connector on the right panel of the SmartClass.
2 Connect the RJ-45 to bed of nails test leads to the desired pair, black to tip(A) and red to
ring(B).
The line is connected.
Setting Description
Server IP Enter the tester’s LAN server IP address.
Netmask Enter the LAN net mask address.
LAN DHCP Server Enable or disable the tester’s DHCP server.
You should enable the DHCP server when the customer’s CPE is config-
ured to receive an IP address automatically.
DHCP Start If DHCP Server is enabled, enter the starting IP address for the tester’s
DHCP server.
DHCP End If DHCP Server is enabled, enter the ending IP address for the tester’s
DHCP server.
Test IP Mode Select the Test IP Mode.
Disabled means the SmartClass Triple Play Services will act only as a
basic router and not do any data tests. (See Figure 9 on page 50.)
Automatic means that the test set will automatically determine an IP
address on the same netmask.
Manual means a specific IP has been assigned for testing.
Test IP Mode If Test IP Mode is set to manual, enter the Test IP.
To Next Page
Loading...
