Chapter 16 Test Results
LAN Statistics
SmartClass TPS User’s Guide
120 22035456, Rev 001 June 2014
LAN Statistics
Table 20 describes the LAN Statistics.
DSL Results
The following section describes the results available in DSL mode. To view the different categories
of statistics, use either the left and right arrows, or press the number for the desired result category.
Summary
This category provides a summary of the most frequently used DSL test results. Table 21 describes
the DSL Summary results.
Table 20 LAN Statistics
Result Definition
Link Status Status of the connection.
RX Bytes Total bytes received
RX Frames Total frames received
RX Errors Total errors received
RX Dropped Total dropped frames received
TX Bytes Total bytes transmitted
TX Frames Total frames transmitted
TX Errors Total errors transmitted
TX Dropped Total dropped frames transmitted
TX Collisions Ethernet frames are transmitted “space-available” when there is a break on the sig-
nal on the cable; sometimes frames are transmitted at the same time as another
transmitter, causing a “collision” of frames.
Table 21 DSL Summary results
Result Description Range
Training State The state of modem synchronization (appears in the
menu heading)
Booting, Idle, Init,
Showtime
Trained Mode The DSL line format agreed upon during training
(appears in the menu heading).
T1.413, READSL,
ADSL2+, ADSL2,
G.Lite, G.DMT, VDSL2
Connection Statistics
Actual Rate Current upstream and downstream connection rates 32 kB–3.3 MB
a
(Up)
32 kB–25 MB
a
(Dn)
64 kB–50 MB (Up)
b
64 kB–100 MB (Dn)
b
To Next Page
Loading...
