Chapter 8 WiFi Testing
Providing WiFi access
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 71
If the WiFi router is connected to a DSL network, similar to Figure 15, select System Settings,
then Remote Access. This enables the WiFi Interface for DSL-to-WiFi.
4 Select End Point Status to view the network status.
5 Select End Point Results to view statistics.
6 If desired, browse the web, place a VoIP call, or run an automatic test.
IP connectivity is verified.
Providing WiFi access
The WiFi AP selection is an Ethernet-to-WiFi bridge mode to create an access point for mobile
devices such as Smart Phones, Tablets, Laptops, and so on. Connection to the internet comes from
the broadband service behind the RG or router. This mode allows the mobile devices to verify
internet connectivity without hunting for CPE passwords, running tests to the CO, or even config-
uring (or reconfiguring) the RG as required.
To provide WiFi access
1 From the WiFi menu, select WiFi AP.
2 Select Network Setup to verify network settings.
a If needed, specify the Wireless Setup as described in “Communicating with a mobile
device” on page 23.
b If needed, specify the Network Setup as described in “Specifying the network setup” on
page 42.
3 If needed, configure the WiFi settings on the mobile device to connect to the SmartClass
Triple Play Services.
Figure 15 DSL-to-WiFi circuit
DSLAM
NETWORK
WiFi
Router
Modem
NID
SmartClass TPS
with Remote WiFi Access
enabled (for DSL-to-WiFi)
To Next Page
Loading...
