JDS Uniphase SmartClass - WiFi results

Chapter 16 Test Results
WiFi results
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 127
Traceroute results
Table 33 describes the trace route results.
WiFi results
The following section describes the results available in WiFi mode.
Status
Table 38 describes the status results. The status may be included on the Access Point Status menu
or the End Point Status menu.
Redirect count The number of times the client was redirected.
HTTP Code HTTP status code message
Header Size Number of bytes in the header
Request Size Number of bytes in the request message
Table 33 Trace route results
Result Definition
State Current state of the trace
Number of hops The number of points crossed from the source to the destination
Table 32 File Transfer results (Continued)
Result Description
Table 34 Status
Result Definition
Status Indicates the link status.
Scanning – Scanning for the SSID configured in setup
Associating – associating to a BSS
Associated – Associated to a BSS. However, the link is not fully up yet.
WPA Handshake – Completing the WPA handshake to set up encryption
Link up – Link is fully up.
SSID The WiFi network ID that you are connected to.
BSSID The access point MAC address.
Signal Strength The strength of the signal, in dBm.
Protocol The WiFi protocol in use (such as IEEE 802.11bg).
Channel The 802.11b/g channel the particular BSS is operating in.
Encryption Type The type of encryption (WPA/WEP)
Maximum BW The maximum bandwidth available on the network.
Network Status Status of the data network.