EasyManua.ls Logo

JDS Uniphase SmartClass - About the automated tests; Running the OneCheck test

Default Icon
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3 Automated Testing
About the automated tests
SmartClass TPS User’s Guide
32 22035456, Rev 001 June 2014
About the automated tests
The SmartClass Triple Play Services includes two automated tests:
OneCheck Allows triple play testing by running a DSL, Ethernet, or WiFi test to verify network
connectivity and upstream/downstream thresholds, a ping test to verify data layer connectivity, a
FTP or HTTP test to verify data upload and download rates, a video test (as described in the video
check below), and a VoIP test. Then the test reports pass/fail results.
VideoCheck — Verifies whether all channels are available as ordered by the subscriber. The test is
included as a part of the OneCheck test, but can be run as a separate test when only the Video
layer needs to be verified.
Running the OneCheck test
The OneCheck test is an automated sequence of tests. The test runs a DSL, Ethernet, or WiFi test
to test connectivity and upstream/downstream thresholds, a ping test to verify connectivity, a FTP
test to verify upload and download rates, a video test to verify the channels are provisioned as the
subscriber requested, and a VoIP test to verify call placement and QoS thresholds.
To run the OneCheck test
1 Launch the desired application: DSL, Ethernet, or WiFi.
2 Select OneCheck.
The OneCheck menu appears. From this menu, you can start the test sequence or go to the
setup menus for each test.
3 To select which tests to run, either highlight the test and then press OK, or press the number
for that test to toggle enabled or disabled.
The only exception is VoIP. Select VoIP and then specify how the OneCheck script will place
the VoIP call:
Automatic – automatically place a call
Manual – display the VoIP call screen and wait for you to initiate the call manually
Disable – don’t run the VoIP test
4 To specify the test settings, press the key, and then select which test to setup.
a Select DSL Setup, and then specify the following:
NOTE:
DSL Setup is only available if testing over DSL. If testing over Ethernet or WiFi, this selection will
not appear.

Table of Contents

Related product manuals