Chapter 2 Instrument Settings
Communicating with a mobile device
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 23
Associating test results to a job
After running your test, you can associate the results to the job using the “Save to job” feature.
See“Saving results to a job” on page 118.
Communicating with a mobile device
Using an app on the mobile device (such as an iPad), you can connect to a SmartClass and control
the user interface.SmartClass TPS supports mobile device applications on both iOS and Android.
Before connecting to the mobile device, configure the SCTriple Play Services to communicate with
the mobile device.
To setup the SmartClass to communicate with the mobile device
1 From the System Settings menu, select Remote Access.
2 Select WiFi Interface.
3 Press OK to toggle Disabled to Enabled.
4 Press the * key to configure the WiFi setup.
To change a setting, use the arrow keys to highlight the item, and then press the OK key to
edit.
a Specify the WiFi Access Point settings.
b If needed, specify the WAN Network Setup (see “Specifying WAN settings” on page 55).
After specifying the SmartClass TPS setup, you can control it with the mobile device.
See “Using the SCTPS with a mobile device” on page 35.
NOTE:
In order to use this feature, the Mobile App Connectivity software option is required.
Setting Description
WiFi Mode Specify Access Point (AP).
SSID The Service Set Identifier is the public name of a wireless
network.
HW Mode Specify whether the wireless network is using 802.11b,
802.11g, or 802.11n
Channel Specify which channel to connect to.
Security Specify the type of security used on the network.
To Next Page
Loading...
