Chapter 14 Optical Tools
Measuring optical power
SmartClass TPS User’s Guide
June 2014 22035456, Rev 001 107
6 To change the measurement mode to relative mode, press the # key.
This sets
the current absolute power level as the new reference value.
7 To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
For descriptions of the results, see “Optical power results” on page 133.
To Next Page
Loading...
