Installation and commissioning
LDM52 OEM, Release 003, Revision 000
5 Installation and commissioning
5.1 Commissioning
Remove the packaging of the LDM52 OEM.
Check the delivery for completeness.
Examine the device and the accessories for damage.
The delivery is without connecting cable.
If the LDM52 OEM should be operated as a stand alone unit a service cable must be prepared
which supplies the LDM52 OEM with voltage and connects the unit to PC (e.g.USB).
Related connector, female inclusive flat cable: FFSD-08-D-06.00-01-N (Samtec)
Where the LDM52 OEM is taken into operation for the first time, we recommend carrying
through the configuration steps at a laboratory or office.
The device can be configured using a communication program.
For example, the program HyperTerminal (included in Win32 operating systems) or any other
communication program can be used.
In order to parameterize the device using a communication program, the LDM52 OEM must be
connected to supply voltage and a PC (see chapter 4.3).
5.2 Mechanical installation conditions
Fastening of LDM52 OEM through the front side with four M2.5 screws.
Please adjust the length of the screws to the local conditions.
The screws are not a part of the delivery.
To Next Page
Loading...
Need help?
General