Jenoptik LDM51 Series User Manual

Parameter setup and measuring operation
LDM52 OEM, Release 003, Revision 000
19
6.4 Status
6.4.1 AS – Autostart
The autostart function defines the behavior of the LDM52 OEM after a cold boot.
After the connection to the supply voltage and the internal start-up routine the LDM52 OEM will
automatically execute the command and send the data to the available outputs.
A figure from the table below must be entered.
The output shows the command.
Query:
AS
Set:
ASx
Range of parameter x:
1 … 6, 13 … 18 (see table below)
Standard:
5
Output: Autostart commands [AS]: DT
Depending on the measurement mode used, it takes max. 6 sec from applying the supply
voltage to the point where the first measured value is put out.
Parameter x see table below
Value x
Command
Meaning
1
ID
Output of device identification
2
ID?
Output of command list
3
TP
Output of internal device temperature
4
DM
Start of individual measurement
5
DT
Start of continuous measurement
6
CT
Start of quick continuous measurement
Following parameters are usable if pin 16/ HEIZ_EN (controller output of external heater) is connected
Value x
Command
Meaning
13
SH
Heating is deactivated
14
SH ID
Heating is deactivated + output of device identification
15
SH TP
Heating is deactivated + output of internal device temperature
16
SH DM
Heating is deactivated + start of individual measurement
17
SH DT
Heating is deactivated + start of continuous measurement
18
SH CT
Heating is deactivated + start of uninterrupted continuous measurement

Jenoptik LDM51 Series Specifications

General

Brand	Jenoptik
Model	LDM51 Series
Category	Measuring Instruments
Language	English