Johnson Controls Tyco PowerSeries Pro User Manual

Chapter 4
2. Press and hold the Stay key for 2 seconds and, if required,
enter the access code or present a proximity tag. Do not leave the
premises.
System is
Ready to Arm
then
Present Tag or
Enter Code
3. If zones have been bypassed, a warning message appears.
4. After successfully initiating the arming sequence the:
l
Armed indicator turns on.
l
Ready indicator remains lit.
l Exit Delay timer begins counting down.
Exit Delay in
Progress
5. To cancel the arming sequence, enter the access code or present a
proximity tag.
System Disarmed
No Alarm Memory
6. Once the exit delay timer expires, the system is armed:
l
Ready indicator turns off.
l
Armed indicator remains on.
l Bypass or system indicator activates.
System Armed
in Stay Mode
4.4.1 Silent Exit Delay
If the system is armed using the Stay key or the No Entry Arming method [*][9]:
l The warning beep is silenced.
l The exit time is doubled for that exit period only (CP-01 versions only).
NOTE: For non CP-01 versions, Standard Exit Time is used.
4.5 Night Arming
Night mode partially activates the alarm system by:
l Bypassing all internal sensors configured as Night zones.
l Arming all perimeter sensors.
l all other internal sensors.
Arming the system in Night mode is possible after the system has first been armed in Stay mode and [*][1]
is pressed at the keypad. The keypad can also be configured with a function key to arm the system in
Night Mode. To access armed interior areas when the system is armed in Night Mode, you must disarm
the system.
NOTE: Ensure that your installer has provided you with a list identifying all programmed night zones.
Your installer can configure a function key to arm the panel in Night mode without the system already
being armed in Stay mode.
To Arm the System in Night mode LCD Display
1. If configured, press and hold the Night Arm key for 2 seconds.
OR
2. Once the system is armed in Stay mode (Armed indicator is on) at
any keypad press [*][*].
OR
press [*][1].
Date Time
JAN 02/13 2:06a
then
Press (*) for <>
Interior Arm
3. If required, enter your access code or present tag. All interior zones
will now be armed, except for devices programmed as Night Zones.
l
The Night mode icon turns on.
Present Tag or
Enter Code
then
Interior Has
Been Armed
- 11 -

Johnson Controls Tyco PowerSeries Pro Specifications

General

Brand	Johnson Controls
Model	Tyco PowerSeries Pro
Category	Security System
Language	English