Chapter 7
7.1.3 Naming a User
Adding or editing labels are accomplished by using the keypad to input the desired letters or numbers.
The following figure depicts the three letters and one number that corresponds to each keypad button.
The first press of the number key displays the first letter. The second press displays the second letter, etc.
[1] [2] [3]
A, B, C, 1 D, E, F, 2 G, H, I, 3
[4] [5] [6]
J, K, L, 4 M, N, O, 5 P, Q, R, 6
[7] [8] [9]
S, T, U, 7 V, W, X, 8 Y, Z, 9,0
[0]
Space
To Edit a User Label LCD Display
1. From the User Codes menu press [3] or scroll to User Labels and
press [*].
Press (*) for <>
User Labels
2. Use the arrow keys [<][>] to move the cursor to a blank space or exist-
ing character.
3. Press the [#] key corresponding to the appropriate letter as shown in
the previous figure.
4. When the required letter or number is displayed use the arrow keys
to scroll to the next letter.
Program Name
{User 1 Label}
5. When finished, press the [*] key.
6. Use the [<][>] keys to scroll to save, then press [*].
7.1.4 Assigning a Partition to a User Code
User codes can be configured to have access only to specific partitions. For more information see
"Managing Partitions".
NOTE: Partitions are configured by your installer.
LCD Display
1. From the desired user press [4] or scroll to Partition Assign and
press [*].
Press (*) for <>
Partition Assign
2. Press [*] to select partition assignment for the user code, select Y
or N.
(*) To Toggle <>
{Partition Lb} Y
- 22 -
To Next Page
Loading...
