Chapter 4
4.0 Securing the Premises
The PowerSeries Pro provides multiple arming modes as described below:
Away Mode
Use this mode when there is nobody on the premises. Away mode activates all peri-
meter and interior sensors in the alarm system.
Stay Mode
Use this mode when someone is on the premises. Stay mode partially activates the
alarm system by arming all perimeter sensors and bypassing all interior sensors.
Night Mode
Use when the perimeter and interior need to be armed but require limited movement
without activating the alarm (e.g., disable motion sensors in an area containing a
washroom). Night mode is similar to Stay mode but only bypasses internal sensors
configured as Night Zones.
NOTE: Verify with the alarm company which modes are available. For SIA FAR listed panels, the Stay
Arming Exit Delay will be twice as long as the Away Arming Exit Delay.
Depending on the system configuration, there are multiple methods to arm the system.
Arm the system using a:
l Keypad
l 2-way Wireless Key
l Proximity Tag
4.1 Arming the System
The PowerSeries Pro system can be armed using a keypad, 2-way wireless key or a proximity tag.
NOTE: If your system is installed in accordance with SIA CP-01 Standard for False Alarm Reduction, the
security system arms in Stay Arm mode if the exit delay time expires and no one has exited the premises.
4.1.1 Away Arming the System with the Keypad
Away mode activates the complete alarm system by:
l Arming all perimeter sensors.
l Arming all interior sensors.
Arm the System in Away Mode LCD Display
1. Ensure all windows and doors are closed and that the Ready indic-
ator is on.
Date Time
JAN 02/18 2:06a
2. To arm using the Away key, press and hold the Away key for 2
seconds and, if required, enter your access code or present a prox-
imity tag or
To Quick Arm the system press [*][0].
System is
Ready to Arm
then
Present Tag or
Enter Code
3. If zones have been bypassed a warning is displayed on the keypad.
Once arming is initiated, the system does the following:
l Armed indicator turns on.
l Ready indicator remains lit.
l Exit Delay timer begins counting down.
l Keypad beeps six times, continues beeping once per second
until beeping rapidly in the final ten seconds.
4. To cancel the arming sequence, enter your access code or present a
proximity tag to the keypad reader.
System Disarmed
No Alarm Memory
5. Once the exit delay timer expires, the system is armed and the fol-
lowing occurs:
l Ready indicator turns off.
l Armed indicator remains on.
l Keypad stops sounding.
System Armed
in Away Mode
NOTE: The installer configures the exit delay timer and the access code if required for arming the system.
- 9 -
To Next Page
Loading...
Need help?
General
