Chapter 4
Zone Label <>
O
O Zone is currently open. You may be unable to arm the
system.
Zone Label <>
B
B Zone is bypassed.
Bypassed zones:
l Must be configured before arming the system.
l Can be configured using a keypad.
l Allow for access to protected areas when the system is armed.
l Allow you to arm the system if a zone is temporarily out of service.
l Reduce the level of security.
l Will not sound an alarm.
l Are automatically cancelled each time the system is disarmed.
l Can be programmed together within bypass groups. For more information see “Bypass Groups”.
4.9.1 Additional Bypass Features
Recall Last
Bypass
Recalls all zones that were bypassed the last time the bypass zone feature was
used.
Bypass All Open
Zones
Allows the user to quickly bypass all open zones with a single command.
Clear Bypass
Instantly clears all bypass conditions from the zones assigned to the partition.
Programming a
Bypass Group
Use when you consistently bypass the same zones. This feature allows you to store
in memory one group of bypassed zones per partition.
Activating a
Bypass Group
Loads a stored bypass group from memory.
NOTE: Ensure that no zones are unintentionally bypassed when arming the system.
NOTE: 24-hour zones can only be unbypassed manually.
NOTE: For security reasons, your installer has programmed the system to prevent you from bypassing
certain zones (e.g., smoke detectors). For more information on fire zones see “Fire and CO Zone Types”.
To Bypass Individual Zones LCD Display
1. Press [*] [1]. If required enter your access code or present your prox-
imity tag.
Zone Bypass <>
(*) To Bypass
2. Directly bypass zones by entering the 3-digit zone #.
OR
Scroll to the desired zone using the [<][>] keys and press [*].
Zone 1 <>
0
3. To toggle and unbypass a zone re-enter the 3-digit zone # or press
[*] again. To bypass more zones repeat steps 3 and 4.
Zone 1 <>
B
4. To exit bypassing mode press [*].
5. If the system is ready to arm the Ready indicator will be lit. When arm-
ing the system, a bypass warning briefly displays.
To Bypass All Open Zones LCD Display
1. Press [*][1]. If required enter your access code or present your prox-
imity tag.
Zone Bypass <>
(*) To Bypass
- 13 -
To Next Page
Loading...
