EasyManua.ls Logo

Johnson Controls Tyco PowerSeries Pro - Carbon Monoxide Detector Guidelines

Johnson Controls Tyco PowerSeries Pro
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 13
13.3 Carbon Monoxide Detectors
Carbon monoxide is colorless, odorless, tasteless, and very toxic, it also moves freely in the air. CO
detectors can measure the concentration and sound a loud alarm before a potentially harmful level is
reached. The human body is most vulnerable to the effects of CO gas during sleeping hours; therefore,
CO detectors should be located in or as near as possible to sleeping areas of the home. For maximum
protection, a CO alarm should be located outside primary sleeping areas or on each level of your home.
Figure 5 indicates the suggested locations in the home.
Do NOT place the CO alarm in the following areas:
l Where the temperature may drop below -10ºC or exceed 40ºC
l Near paint thinner fumes
l Within 5 feet (1.5m) of open flame appliances such as furnaces, stoves and fireplaces
l In exhaust streams from gas engines, vents, flues or chimneys
l Do not place in close proximity to an automobile exhaust pipe; this will damage the detector
PLEASE REFER TO THE CO DETECTOR INSTALLATION AND OPERATING INSTRUCTION SHEET
FOR SAFETY INSTRUCTIONS AND EMERGENCY INFORMATION.
- 44 -

Table of Contents

Related product manuals