Johnson Controls Tyco PowerSeries Pro User Manual

Chapter 4
3. Press [9][9][5] to program the bypass group with the currently
bypassed zones
OR
Scroll to Bypass Options using the [<][>] keys and press [*]. Scroll to
Program Bypass Group and press [*].
Press (*) for <>
Prg Bypass Group
4. The Bypass Group is now programmed.
Bypass Group
Programmed
5. To exit bypassing mode and return to the Ready state, press [#].
To Load a Bypass Group LCD Display
1. Press [*][1]. If required enter your access code or present proximity
tag.
Scroll to <>
Bypass Zones
2. Press or [9][9][1]. If required enter your access code or present your
proximity tag.
OR
Scroll to Bypass Options using the [<][>] keys and press [*]. Scroll to
Bypass Group and press [*].
Press (*) for <>
Bypass Group
3. The group of zones are now bypassed. A bypass group message
briefly displays.
4. To exit bypassing mode and return to the Ready state, press [#].
4.11 Arming Troubles and Exit Faults
The PowerSeries Pro notifies you of troubles when you are attempting to arm the system or exit the
premises.
4.11.1 Arming Troubles
An error tone (long beep) sounds if the system is unable to arm. Arming trouble occur if:
l The system is not ready to arm (i.e., sensors are open).
l An incorrect user code is entered.
l A trouble is present and has not been viewed by the user. This operation must be enabled by the
installer.
To Correct an Arming Error
1. Ensure all sensors are secure. Your keypad will identify any open sensors.
2. When the trouble light is on, enter [*][2] and enter [99] or scroll to the Acknowledge All Troubles
prompt and press [*]. NOTE: If your system has been programmed to prevent armingwhen a trouble
is present.
3. Try arming the system again.
4. If troubles persist contact your installer.
4.11.2 Audible Exit Faults
NOTE: This option must be enabled by your installer.
In an attempt to reduce false alarms, the Audible Exit Fault notifies you of an improper exit when arming
the system. Improper exits are caused by failing to securely close the Exit/Entry door.
Improper exits cause the following system notifications:
l The keypad emits one continuous beep.
l The bell or siren sounds for the duration of the entry delay until a valid user code is entered or
until the programmed Bell Time Out expires.
4.11.3 To Correct an Exit Fault
1. Re-enter the premises.
2. Disarm the system before the entry delay timer expires by entering your access code.
- 15 -

Johnson Controls Tyco PowerSeries Pro Specifications

General

Brand	Johnson Controls
Model	Tyco PowerSeries Pro
Category	Security System
Language	English