Johnson Controls Tyco PowerSeries Pro - Additional System Features; Zone Temp, Chime, Verification, and Outputs

10.0 Additional Features
10.1 Display Temperature For All Zones
This feature displays the temperature for each enabled zone.
To view zone temperature LCD Display
1. Press [*] in the main menu on any partitioned keypad.
Press (*) for <>
Temperature
2. Press [*] to select temperature. For quick access press [*][*] (example
display shown).
3. Scroll through the menu to view the temperature capable zones.
4. Press [#] to exit.
Back Door < >
Basement -11°C
NOTE: This feature must be enabled by your installer.
10.2 Turning the Chime ON/OFF
Turning the chime on audibly notifies you when an entry/exit sensor is activated.
To turn the Chime ON or OFF LCD Display
l
Press the Chime key or [*][4] to toggle the Chime function On
or Off for the current partition. An access code may be required to
change this setting.
Door Chime
Feature ON
Door Chime
Feature OFF
10.3 Audio Verification
Allows the monitoring station to initiate a 2-way audio (talk/listen) or 1-way audio (listen-in only) session
when an alarm has been received. This feature is used to verify the nature of the alarm or determine the
type of assistance required by the occupant.
NOTE: This is a supplementary feature that has not been investigated by UL/ULC.
NOTE: Must be enabled and configured by installer.
10.4 Visual Verification
Allows the monitoring station to use video clips captured from system motion cameras for verification of
any alarms.
NOTE: This is a supplementary feature that has not been investigated by UL/ULC.
NOTE: Must be enabled and configured by installer.
10.5 Command Outputs
While being useful for many applications, Command outputs are typically configured to operate items
such as garage doors or electric gates. Additionally, command outputs can be assigned to follow a sched-
ule configured by your installer.
This is a supplementary feature that has not been investigated by UL/ULC.
Must be configured by installer.
To Activate a Command Output LCD Display
1. Press [*][7] and if required enter your [access code].
OR
press [*] and use the scroll keys to navigate to Output Control.
Output Control <>
Scroll to View
2. Press the number configured to the command output
OR
use the scroll keys to navigate to the desired command output and
press [*].
Output
Activated
- 31 -
Chapter 10