Chapter 3
3.5 Monitoring
This system is capable of transmitting alarms, troubles and emergency information. If an alarm is initiated
by mistake, immediately call the central station to prevent an unnecessary response.
NOTE: For CP-01 systems, the monitoring function must be enabled by the installer before it is oper-
ational. There is a communicator delay of 30 seconds in this control panel. It can be removed, or it can be
increased up to 45 seconds, at the option of the end-user by consulting with the installer. Fire type alarms
are normally reported without a delay.
3.6 Maintenance
Keep your alarm controller in optimal condition by following the instructions included within this manual
and/or marked on the product. The end user and/or installer are responsible for disposing of used bat-
teries according to local waste recovery and recycling regulations.
l Use the system test described in “Testing the System” to check the battery condition. We recom-
mend, however, that the standby batteries be replaced every 3-5 years.
l For other system devices such as smoke detectors, motion detectors or glassbreak detectors, con-
sult the manufacturer’s literature for testing and maintenance instructions.
l Lightly dust the security equipment with a slightly moistened cloth.
NOTE: Do not use abrasives, thinners, solvents or aerosol cleaners (spray polish) that may enter
through holes in the Alarm Controller and cause damage. Do not wipe the front cover with alco-
hol, water or any other liquid.
3.7 Applicable Models
This publication covers the following models: x = 9 (912-919MHz UL/ULC systems), 4 (433MHz) or 8
(868MHz).
HS3032 HS2LCDRFPx
HS3128 HS2LCDWFx
HS2LCD(P) HS2LCDWFPx
HS2LCDRFx HS2LCDWFPVx
- 8 -
To Next Page
Loading...
