Chapter 4
To gain access to interior areas that are armed during Night mode disarm the system by entering your
access code.
4.6 No-Entry Arming
No-Entry Arming arms the system in Stay mode by:
l Removing the Entry Delay from all configured zones.
l Arming all perimeter sensors.
l Bypassing all interior sensors.
An entry through any door or window will create an instant alarm.
To No-Entry Arm the System LCD Display
1. Check that the Ready indicator is on and your system is ready to
be armed.
Date Time
JAN 02/18 2:06a
2. Press [*][9] and, if required, enter your access code or present your
proximity tag.
Present Tag or
Enter Code
3. If zones have been bypassed, a warning message appears.
4. After successfully initiating the arming sequence the:
l Armed light flashes as a reminder that the system is armed and
has no entry delay.
l Keypad sounds fast beeps.
l Exit Delay in Progress is displayed
Armed With No
Entry Delay
5. To cancel the arming sequence, enter your access code or present
your proximity tag.
System Disarmed
No Alarm Memory
6. Once the exit delay timer expires, the system is armed.
System Armed
in Stay Mode
4.7 Exit Delay Time Restart
This option restarts the exit delay timer if an entry/exit zone is tripped a second time before the end of the
exit delay. The exit delay timer can only be restarted once.
4.8 Leaving when the System is Already Armed - Quick Exit
Use the Quick Exit feature if the system is already armed and you would like to leave without disarming
and rearming the system. Quick Exit uses the same hot keys as Quick Arming, and it provides you with a
2-minute exit delay to leave the premises without triggering an alarm. Once the door you leave from
closes, the quick exit timer will be canceled.
To Quick Exit LCD Display
1. When the system is already armed and the Armed light is lit, press
and hold the Quick Exit key for 2 seconds
OR
press [*][0].
Quick Exit in
Progress
2. Exit the premises before the exit delay timer expires. After exiting, the
delay timer will be canceled.
4.9 Bypassing Zones
WARNING! If a zone is not operating properly contact a service person immediately.
Bypassing zones intentionally unprotects specified zones the next time your system is armed. Depending
on the type of keypad, bypassed zones will be identified differently. Using an HS2LCD series keypad,
bypassed zones are indicated on the LCD screen as shown in the following table.
NOTE: For UL listed installations, zones can only be bypassed manually.
LCD Display Indication Description
Zone Label <>
none Zone is ready for arming.
LCD Keypad Zone Indications
- 12 -
To Next Page
Loading...
Need help?
General
