Chapter 2
2.0 Safety Instructions
North America
This equipment is cord connected, pluggable Type A, stationary with a non-detachable power supply
cord and must be installed by skilled persons only (persons who have training or experience in the equip-
ment technology, particularly in knowing the various energies and energy magnitudes used in the equip-
ment). It must be installed and used within an environment that has maximum pollution degree of 2, over-
voltages category II, in non-hazardous, indoor locations only.
WARNING! This equipment has no mains on/off switch; if the equipment must be quickly dis-
connected, the plug of the power supply cord serves as a means of disconnection; it is imperative
that access to the mains plug and associated mains socket/outlet is never obstructed.
International (EU, Australia, New Zealand)
This equipment is stationary-fixed and must be installed by Skilled Person only (Skilled Person is defined
as a person with relevant education or experience to enable him or her to identify hazards and to take
appropriate actions to reduce the risks of injury to themselves and others). It must be installed and used
within an environment that provides the pollution degree max 2, over voltages category II, in non-haz-
ardous, indoor locations only.
WARNING! When using equipment connected to the mains and/or to the telecommunication network,
there are basic safety instructions that should always be followed. Refer to the safety instructions
provided with this product and save them for future reference. To reduce the risk of fire, electric
shock and/or injury, observe the following.
l Do not attempt to open or service this product. Opening or removing the cover may expose you to
dangerous voltage or other risks. Servicing must be done by skilled persons only.
l l Use only authorized accessories with this equipment.
l Do not leave and/or deposit any object on the top of the cabinet of this equipment. The cabinet is
not designed to support any supplementary weight.
l Do not touch the equipment and its connected cables during an electrical storm; there may be a
risk of electric shock.
l l Never touch uninsulated wires or terminals unless the equipment has been disconnected from
the mains supply and from the telecommunication network.
l Ensure that cables are positioned so that accidents cannot occur. Connected cables must not be
subject to excessive mechanical strain.
l Do not spill any type of liquid on the equipment.
l Do not use the alarm system to report a gas leak if the system is near a leak.
l This equipment contains no user-serviceable parts, except for the keypad batteries.
l Dispose of used batteries as per local rules and regulations.
These safety instructions should not prevent you from contacting the distributor and/or the manufacturer
to obtain any further clarification and/or answers to any concerns.
- 6 -
To Next Page
Loading...
Need help?
General
