Johnson Controls YORK OPTIVIEW CONTROL CENTER - Page 130

JOHNSON CONTROLS
130
FORM 160.10-O1
ISSUE DATE: 4/27/2018
SECTION 4 - PRINTERS
[Not if Motor Type is not Mod B SSS]
Liquid-Cooled Solid State Starter
-----------------------------------------------------
Local Motor Current Limit = 100 %
Remote ISN Current Limit = 100 %
Remote Analog Current Limit = 100 %
Remote Digital Current Limit = 100 %
Remote Modem Current Limit = 100 %
Pulldown Demand Limit = 100 %
Pulldown Demand Time = 0 Min
Starter Model = 26L
Voltage Range = 440 - 480
Full Load Amps = 275 A
Starting Current = 1150 A
Open SCR = Enabled
Shorted SCR = Disabled
[Skip the following section if Motor Type is not VSD]
Variable Speed Drive
-----------------------------------------------------
Local Motor Current Limit = 100 %
Remote ISN Current Limit = 100 %
Remote Analog Current Limit = 100 %
Remote Digital Current Limit = 100 %
Remote Modem Current Limit = 100 %
Pulldown Demand Limit = 100 %
Pulldown Demand Time = 0 Min
Motor HP = 351 HP
Power Line Frequency = 60 Hz
[Skip the following section if Motor Type is not VSD]
Harmonic Filter Data
-----------------------------------------------------
Filter Operation = Enabled
Motor HP = 351 HP
[Skip the following section if Motor Type is not VSD]
Adaptive Capacity Control
-----------------------------------------------------
Surge Margin Adjust = 0 Hz
Stability Limit = 4500
FIGURE 52 - SAMPLE PRINTOUT (SETPOINTS)
(CONT’D)