36
CCPM Linkage Connection
Assemble and adjust the three CCPM servo linkages as
shown below. It is important that the exact distances specified
below be maintained for each linkage as this is critical to the
alignment and neutral position of the swashplate. Please also note
the direction of the ball links as shown by the “JR Propo” name
imprinted on each ball link. The “JR Propo” name is imprinted on
the front of each ball link. When attaching the control rods, it is
important to make sure that the “JR Propo” name faces outward
as the links are attached to the control balls.
Please also note that when attaching control
linkages B and C, it will be necessary to rotate the
link that attaches to the swashplate slightly so that it
is parallel to the rear mounting surface of the ball link.
This will allow the control linkage to rotate slightly on
the two control balls. It is also recommended that the
JR ball link sizing tool be used to size the ball links
for a proper fit prior to attachment.
Front Servo to Swashplate Linkage
2.3 x 65 mm Threaded Rod
Left Servo to Swashplate Linkage
2.3 x 20 mm Threaded Rod
11.5 mm
49.5 mm
Right Servo to Swashplate Lonkage
2.3 x 40 mm Threaded Rod
22.5 mm
To Next Page
Loading...
