CCPM Exponential (EXP)
H-19
The purpose of this exponential is to remove the non-
linear, or rough movement of the swashplate due to the
mechanical differential of the servo horn.
This will be a help to change circular movement of servo
horn to linear movement. The Exponential function can be
turned on and off by highlighting the EXP function with
the Rolling Selector, then pressing the Rolling Selector to
select INH (Off) or ACT (On). Note: it is recommended that
EXP be activated in most cases.
Accessing the Swashplate Mixing Function
1. Place the transmitter power switch in the ON position.
2. Access the Function Mode by pressing the LIST key.
3. Move the Rolling Selector and highlight Swash
Mix. Press the Rolling Selector to access.
4. Move the Rolling Selector until the desired channel
to be adjusted is highlighted.
5. Press the Rolling Selector, then rotate left and right to
increase/decrease the CCPM Travel values as needed.
6. Follow the same procedure for the remaining channels.
7. To exit the Swashplate Type function, move the Rolling
Selector to highlight LIST, then press.
[Swash Mix]
3servos
140
o
AILE 60%
ELEV 60%
PIT. 60%
EXP ACT
To Next Page
Loading...
Need help?
General
