JR X9303 - Swashplate Timing: Aileron-To-Elevator (Corrects Rolling Maneuvers)

Swashplate Timing: Aileron-to-Elevator (Corrects Rolling Maneuvers)
H-37
This form of mix functions and is set up exactly as we
have outlined in the Elevator-to-Aileron Mix section, and
allows the helicopter to roll more axial along the Tail
Boom of the model by adding a slight amount of Elevator
to each direction of Aileron.
Setup Tip: Most helicopters that have a Clockwise
Rotation Rotor require a small amout of Up Elevator
for right rolls, and a small amount of Down Elevator
for left rolls.
Highlight and select one of the Standard Programmable
Mixers (PROG.MIX3PROG.MIX6) to obtain the first
Programmable Mix display. Then press ACT next to
CLR or highlight and select INH to obtain the main mix
display. The example is using PROG.MIX3.
[PROG.Mix3]◊0
AILE≥ELEV
Pos0 +5%
Pos0 +5%
Pos0 0%
0%
Offset
0
NRM ST1 ST2 HLD GER
POS1
POS0