Copy (continued)
H-4
3. Verify that the top model is the model that is to be
backed-up and the lower model is empty or contains
a model that is no longer required. When satisfied
that all is well, press the CLR button on the left side
of the display next to COPY. The entire contents of the
currently selected model are copied to the lower model
on the display and there is now a complete backup of
the current model. The upper and lower model memory
names are now the same because they are now
identical in every regard.
The backup copy can now be used to restore the original at
any time by performing the Copy function and reversing the
order of models where the backup is copied into the original.
Note: As the X9303 2.4 has the ModelMatch feature,
in order to operate the receiver on a new model
number, you must first re-bind the receiver to the
new model in order for it to function.
To change the lower model memory that is to receive the
copy of the current model, highlight and select the lower
model name and number. Then scroll to an unused model
memory or a memory that contains data that is no longer
required, and select it.
Copy
[Model SEL]
MODEL 3 HELI
MODEL 3 HELI SPCM
MODEL 2 ACRO
MODEL 4 HELI
MODEL 5 ACRO
To Next Page
Loading...
