MULTI-POINT MIXES – FMOD to Gear (continued)
H-43
5. Set Points for Travel and Direction. There are
7 points displayed. A negative value at a point
typically indicates a Gear Up movement at that point
and a positive value, a Gear Down movement. The
direction of travel may be reversed (Up Gear vs. Down
Gear) by changing values from negative (-) to positive
(+) (moving the point values above and below the
0% line).
Set the points initially to the following values.
Point-0 -0%
Point-1 +80% (Normal Mode, Gear Down)
Point-2 -80% (Stunt 1, Gear Up)
Point-3 -80% (Stunt 2, Gear Up)
Point-4 INH (Stunt 3 if Activated)
Point-5 INH (Stunt 4 if Activated)
Point-6 +80% (Throttle Hold, Gear Down)
7. EXP (Expo). With this mixing example, it is not
necessary to activate the Expo option.
8. Verify Operation. Power up the receiver, making sure
that the heli is elevated for the first time in case the
Gear is functioning in the opposite direction desired.
Move the Flight Mode and Throttle Hold switches,
and note the position (Up or Down) of the retracts. If
the retracts are functioning in the opposite direction
desired, then enter the mix again and change the value
from a + to a -, or a – to a + as needed and retest.
To Next Page
Loading...
