2.5.2.8 NMEA Talker (NMEA TALKER)
With this menu, some additional NMEA sentence filters can be applied on the address field of an NMEA sentence. The
address field consists of a talker ID and a sentence formatter (for example ROT). This is depending on the configuration
of the software.
• TALKER- This item is prepared for future expansion, it is now set to **, which means that the NMEA (IEC61162-1)
Talker ID is not checked. Any talker ID is always accepted with the selected sentence formatter.
• USED/UNUSED - This setting defines the acceptation of the sentence based on the combination of the selected
Talker ID and selected sentence formatter. If this is set to UNUSED all sentences formatted with the selected Talker
ID are ignored. For now, this makes it possible for example to reject some specific sentence formatter.
Figure 42: NMEA Talker Menu
1. In the MENU, touch the ADV SET button.
The PASSWORD screen appears.
2. Key in the password and confirm with the
√
button.
The ADVANCED SETTINGS MENU appears.
3. Touch the NMEA TALKER button.
4. Select the correct sentence formatter by touching the < or > buttons.
INFO: The TALKER is fixed indicated as a "Wild card" by **.
5. Touch the + or – buttons to select USED or UNUSED.
6. Touch the
√
button to confirm.
44 | Operation
To Next Page
Loading...
Need help?
General
