JRC JHS-183 - Display Setup of Other Ships List

5-10
5.2.1.4 Display Setup of Other Ships List
In order to change the display setting of other ship list, press SUB key at “LIST SORT” screen for other
ships list and switch to SUB screen.
When the screen is switched from the SUB menu screen to “LIST SORT” screen, press CLR key or
select [EXIT], and then press ENT key.
At SUB menu screen, Other ship’s bearing basis, sorting of range, TCPA or
own group priority order,
and ship’ s name indication in “LIST SORT” screen (upper left figure) can be set.
Select item at the SUB screen and press ENT key, then select a desirable indication and press ENT
key again.
1. BEARING: HEAD UP : Other ship’s bearing value is displayed on the basis of own ship’s bearing.
NORTH UP : Other ship’s bearing value is displayed with the north base.
2. SORT : RANGE : Other ships are displayed in the order of small range from own ship.
TCPA : Other ships are displayed in the order of small TCPA with own ship.
GROUP : Other ships are displayed with the priority for own group ships.
3. NAME : SHIP NAME : When receiving static information, the ship’s NAME is displayed.
MMSI : Ship’s MMSI is displayed.
4. DISP : NORMAL : “LIST SORT” screen is displayed with BRG, RNG, ET and NAME.
TYPE 1 : “LIST SORT” screen is displayed with BRG, RNG, and NAME.
TYPE 2 : “LIST SORT” screen is displayed with BRG, and NAME.
“ETmin” means the “elapsed time” from the last data received, After 7 minutes elapsed, the ship is
erased from the other ship’s list. After 18 minutes elapsed, the AIS-SART is erased from the other ship’s
list.
Select [SET] and then press ENT key to determine. “LIST SORT” screen for other ships list is displayed
with the setting.
SUB
or
CLR
LIST SORT:RANGE
BRG
°
RNG
NM
ET
m
in NAME
219 0.20 1 SART
152 0.44 2 JRC0>
192 1.30 3 JRC0>
72 1.46 0 TOKY>
▼ 215 3.64 5 AICH>
2
/
200
LIST DISP.SET
*SUB MENU*
1.BEARING:NORTH UP
2.SORT:RANGE
3.NAME:SHIP NAME
4.DISP:NORMAL
▼
[
SET
]
1
/
2
LIST DISP.SET
*SUB MENU*
▲
[
EXIT
]
2
/
2
▲
or
▼