JRC JHS-183 - 5.3.4.11 Silent Mode (Prohibit Transmission)

5-63
5.3.4.11 Prohibition of Transmission（SILENT MODE）
Select 11.SILENT MODE and enter password. Silent mode is available.
This is used for intentional prohibition of transmission.
Caution：Normally, AIS is operated by regulated channels.
Ship’s administrators must be responsible for any change.
Select from ON or OFF with ▲ key or ▼ key.
OFF ･･･ Continue normal operation
ON ････ Prohibit from transmitting while selected.
Press ENT key to determine.
When the AIS is prohibited from transmitting, there is always “RX” mark on the bottom line of screen.
5.3.4.12 CCRP Set
Select 12.CCRP SET, The use of CCRP (Consistent Common Reference Point) can be selected.
The AIS will display the distance or compass direction on the basis of the CCRP setting.
Select from ON or OFF with ▲ key or ▼ key.
OFF ･･･ Set AIS controller’s position as the reference
point.
ON ････ Set CCRP for as the reference point
Press ENT key to determine.
SET UP
▲
7.PASSWORD
8.POSN DISP SET:ON
9.SART TEST SET:OFF
10.LONG-RANGE SET
11.SILENT MODE:OFF
12.CCRP SET:OFF
2/2
▼
SET UP
▲
7.PASSWORD
8.POSN DISP SET:ON
9.SART TEST SET:OFF
10.LONG-RANGE SET
11.SILENT MODE:OFF
12.CCRP SET:OFF
2/2
▼